| Author: |
| ||||
| Subject: |
| ||||
| Message: | Patrick, Just came in from the shop, the engine light comes on & stays on as long as the key is in the position 2...darn... I disconnected one dk, turned on the key to position 2, applying pressure on the gas pedal made the dk rotate to about 2/3 of open, I connected the other dk (on it's own) & it rotated to 2/3 open too, unfortunatly when both where connected again they would only move about 2-5 degrees. It's as if there isn't enough power to run both motors...my voltage reading is correct though. I'll clean my dk's again tonnight, maybe I overlooked something. thanks Jaydee P.S. I got a used OBC this morning & installed it as soon as I got back at the shop. It works great, the cliking is gone. | ||||
© 1997 -
2009
Jump Internet Inc. All rights reserved.
