| Author: |
| ||||
| Subject: |
| ||||
| Message: | I'll be surprised if new relays help, none of the items you list go through the unloader or any other relay. If you look at the ETM you will see that the Turn Signal (fuse 4), Wipers (fuse 5), and Brake (fuse 6) all have one thing in common, they all are powered by pin "R" of the key when it is in the Accy, Run, or Start position. The next time it happens, check for power at pin 4 of C200 (under the drivers kick panel-See ETM 7000-3 for location). If there is power, then check pin 8 of C114 on the underside of the printed circuit board for cold solder joints. (See ETM 0670-2) On second thought, since wiggling the relays (i.e. the printed circuit board) helps, I'd probably start with pin 8 of C114 inside the fuse box. Check and make sure you are getting power from the key. to pin 8. | ||||